![]() After extraction is complete, the installation script named install is executed to begin the install process. The archive is a tar archive compressed with gzip, and headed with a shell script to facilitate self-extracting. The Linux version of PaperCut NG/MF is supplied in a self-extracting, self-installing archive. This section describes the installation process in detail as well as some additional options available to SysAdmins. Due to the varied nature of some installations and administrator preferences, often some manual configuration is required. The installation process is designed to work with all major Linux distributions. The Linux version of PaperCut NG/MF is supplied as a pre-compiled self-installing application. sudo init 0 to shutdown or sudo init 6 to reboot.Īll these commands are executed on the command line unless otherwise stated.Įach connection of the release station requires a PaperCut release station license (one connection license is included in the base product for testing).Įvery time the Raspberry Pi reboots it will automatically perform a file system check and repair.PRODUCTS FEATURED The installation process Login as user admin and do whatever you need to do. To shut the release station down or perform system maintenance: On the current image password for papercut user is secure and unknown. On the current image password for admin user is password. Run the command sudo init 6 to reboot the Pi Note that in order to configure a keyboard you will need a USB keyboard connected to the Pi, even if you are connected across a network ![]() Set the options options for your region (i.e. ![]() _raspi-config#Running_raspi-config_another_time for more information. Sudo apt-get update & sudo apt-get upgrade -y & sudo apt-get dist-upgrade -y Make sure the operating system is fully up to date with the command: On images before release 16.3 it’s username pi and password raspberry. Login as the admin account, currently username admin and password password. On newer versions (16.3 and above) of the release station image you will be reminded to configure the keyboard, timezone and locale (see below).įrom a workstation on the same network use ssh to connect to release station. ![]() It should (eventually) boot up into the release station display or display an error message that it cannot contact the PaperCut application server. Insert the SD card into your Pi and power it up. Unmount the SD card from the workstation. On newer versions (16.3 and above) of the release station image you can also configure the wifi settings and hostname by editing the file It contains the IP address of the PaperCut application server and the port number to use for communication. Follow the standard release station documentation With the SD card still mounted (it may be need to re-inserted to force a re-mount) in the workstation edit the following files in /boot: Instructions to do this can be found at the following links. On a workstation (Mac, Windows or Linux) download and unzip the PaperCut Raspberry PI Release Station image from the above link.Ĭopy the image to a suitable SD card (NB the current image will fit on a 4GB card). It is very unlikely that a Pi Zero or a Raspberry Pi model A will be suitable because of a lack of network and USB connections. The instructions assume some basic understanding of managing Raspberry Pis and using the Linux command line. Setup instructions for the Raspberry Pi Release Station
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |